IllustratorCS制作刺繡效果(20201206213827)

1、Illustrator CS制作刺繡效果 話I I佝匚空 也凹血-H Untitld-1 200% (RGB/Preview) ”新建RGB棋式文件 2/輸入Al Club字符 Arialfilack 36pt 莎再原位SI制為個 ? T / I i in ft. T / I ilk 八 J Al Club Scribble Options r / I iin /*r Scribble Options r Angle: Inside Outside A Centered 5 None Path Overlap:0 Variation:|0 mm Can cel ) 0 Preview Wide

2、 Line Options Stroke Width: 0.25 mm | S- Curviness: p % Anquhr Loopy Spacing: |0.4 mm S Tight Loose Variation: 中間 1 1% None Wide Variation: 0.1 mm None Wide Al Club Scribble Options Settings: Custom Angle: Path Overlap: |*0.53 mrr Variatio n:021 mm Inside 4 Centered Outside None Wide OK Can cel 0 Pr

3、eview 一 Line Options Tight Loose None Variation:0 Variatio n:0.1 mm 然后是最上面一層亮面部分 l% Wide None Wide Al Club 整依觀乗一下.自己調(diào)整一下明暗色彩 Scribble Options Setti ngs: Custom Angle:0 * Path Overlap: |0 mm Variation:|0 mm 5 InsideCenteredOutside a None Wide Cancel 0 Preview 0 Preview 現(xiàn)在制作外面的繡邊： 復制=卞最后的深紅層至 Line Opt

4、ions Loose Tight 下面.同 出述方法 Wide 4 None T / I i in fit Scribble Options Setti ngs: Cullum Angle:0 Path Overlap: |0 mm Variation:0 mm Inside Centered Outside None V/ide Line Options Loose A None Tight Variation:0 宴制灰魚卑至上面，調(diào)淡 顏色為繡邊的中間色調(diào)， 再如圖 l% V/ide Variation: None V/ide ?.T /l I ir. /*r. Angle: 0 f5

5、Path Overlap: Inside 2- Centered Outside Variation: None Cancel 0 Previe Wide Stroke Width: |0.14 mm | S- Curvi ness: I?% Angular Loopy Spacing: 0.6 mm | *37 Tight Loose Line Options 再復制一混 中間色上面 作為亮面在 ,如圖 Variation: l _% None Wide Variation: |0.1 mm None Wide ?.T / I i ir Drop Shadow Options 一 Mode:

6、 Opacity: X Offset: Y Offset: Multiply mm Blur: 0 Color: 10.2 mm| Cancel 丿 Preview 最后修許: 最下面氏深灰繡邊加投影. EffectStyleDropShadow 0 Darkness: Al Club Drop Shadow Options 一 Mode: 5)Color: Cancel Multiply Opacity: X Offset: Y Offset: Blur: Preview 紅色繡寧的最下面一層同樣 制作陰影. Darkness: Scribble Options Setti ngs:Custom Angle: Path Overlap:-0.26 mrr( Variation:|0.21 mm 0 Pre、 InsideCentered Outside None Wide Line Options 為使剌繡紋理更自然些，再 Variation: Variation: Loose T Tight None 繡字的最上一層至最前面, 后，如圖 Wde |0.1 mm